Web Analytics

Thule Winter sport racks let you live your winter passion thanks to a full choice of ski and snowboard racks. Not to mention ski boxes that also let you store your boots and poles plus all your other gear. Just load everything you want and head for the snow. And you can always be sure your equipment arrives in perfect shape – at the Thule Test Center™ we rigorously test our winter sport racks for road safety as well as their ability to withstand extreme weather. Leaving you free to think about the adventure ahead!

I took my time fitting the parts of the Thule Wing bar system together and making sure that they were positioned and setup on the car correctly. I made sure that when positioned I took a note of what the feet of the bars lined up with. In my case they lined up with a couple bits of trim near the B pillar and rear door. This did take some time to get just so, but was worth it as they can now be fitted to the car in a matter of minutes.

I purchased a 2015 F150 and needed to upgrade my load bars for my Thule Kayak Hullavator system. I was using 58" bars on a 2013 F150 and they were just barely long enough. After measuring the old bars (58") on the new truck, I was worried they wouldn't be wide enough for my Hullavator system so I purchased the 65" bars (as suggested by Thule). I'm glad I did as the shorter bars would have allowed the kayak lift to hit the side of my truck.

I’ve spent years transporting bikes in the back of a car, usually whipping out the front wheel, throwing an old grease stained fleece blanket over it and slamming the boot shut before heading off. Bags would be placed carefully around it of course and it took a little more finessing if I was taking a friend and their bike. But I became fairly adept at balancing bikes on top of each other – separated by blankets – and avoiding any damaging movement.
The lid has dual-layer construction, which adds stiffness for durability and ease-of-use while reducing drag for better MPG, as well as to lessen the noise. Spring-loaded hinges make accessing the box from either side of the vehicle a breeze, with lockable Smartlatch handles help make sure everything is shut up tight. Clamp mounts make the box compatible with most roof rack bar systems, though you’ll probably want to upgrade to one of Whispbar’s mounts to complete the look.
Bought for use on my van's roof to hold a 9'1 longboard - already had roof bars up there which turned out to be too thick for the supplied fixings but wasn't too difficult to make it work. Really quick and easy to use. Haven't tried it with two boards but, as some of the other reviews say, it could be a bit tight to fit another board in with the size of strap supplied.
Long road trips and overlanding adventures are only done right when you pack until your vehicle is almost overflowing. But if you’re playing Tetris with bags and your truck is bursting at the welds, chances are you won’t be able to see anything out the rear window — and that’s not safe. Roof racks are great for spreading gear to the often unused and underutilized space on the roof, but also for storing gear that won’t fit in your car to begin with. Paddleboards, mountain bikes and kayaks should all ride topside, especially after a long weekend of hard use.
I can't comment on J carriers because I don't use them, but perhaps I should. The design weakness with Thule is the square bars, which only becomes a problem on curved roofs, but as the roof curves so must cradles cant away from each other, reducing contact between boat hull and cradle to inside edges. The cradle faces are absurdly small to start with; this rotational deviation from level makes it even smaller. Couple that with Thule's comically inadequate détente angle fixing clamp (for holding the saddle in the shape of your boat hull) and for support you are probably better off using foam blocks. So J carriers may work better on a curved roof, if I can lift that high. I've seen some people use them for composite boats so it might be OK.
The most likely causes of excessive wobble at speed on a motorway are either that you have not placed the arm clamp sufficiently close to the chainring OR you have not tightened the clamp sufficiently. Having said that, there is a further cause where the clamp can slip UP the frame IF your frame gets thinner in that direction (eg My Cervelo S3 does precisely that). In that scenario you will need to put the arm clamp slightly further away from the chainrings at a thinner part of the frame.
I must confess that I've used the 815s without bow or stern tie-downs, but my two kayaks have not budged at all. I peek at them through the moonroof on my car from time to time, and they've never shifted. It's important that you read the directions on how to secure the two strap assemblies. If you do it correctly, they will not loosen. Thule's buckle bumpers are pure genius for protecting your car and your boat. When I get home one night with only one kayak on the roof, I entered my garage before the door had fully opened. The bow of the kayak hit the bottom lightweight insulated aluminum panel of my garage door and crumpled it, but the kayak didn't budge (nor did it get damaged, phew!). However, in the interest of safety, I have resolved to use bow and stern tie-downs in the future. To this end, I have purchased and installed bow hood loops from Riverside Cartop Carriers on my car.

Anti-Sway Cages – There are a few different ways that racks can be designed to minimize sway, but an anti-sway cage is the most widely used. In particular, you’ll find these on rack designs that hold the top tube, but rear mounted designs that lock the wheels can also benefit from built-in anti-sway tech. In essence, it’s just going to help to keep the bike stable in the rack as you drive. This has the dual benefit of not allowing the bikes to affect vehicle handling (especially at highway speeds) and also stops the bikes knocking into each other.
I bought this as an upgrade since we bought the Toyota Sequoia which is wider than my older Mercedes GL. I also ordered the Thule Outrigger which works nicely with the cross bar to load and unload our SUPs easier. The combination works very well. I offer a suggestion I did which also worked well with me. If you want kayaks or boards to roll easily over the cross bars and without scratching try this: Go to Home Depot and buy two 30-40" long (depending on the width of the car top) of 1.5" diameter PVC pipes and two-2" pipes of the same length. The 1.5" will fit inside the 2" pipe nicely and the cross bar will fit into the combination (through the 1.5" of course) very well. This will give you a very nice set of rollers for the two cross bars and if you buy the black color of pipes they will look very professional at a cost of less than $15. I tried so many commercial covers and rollers and nothing worked better than this home made one.
Once your base support roof rack is fitted, you can use accessories to adapt it for all kinds of transport storage--from covered roof boxes to racks for bicycles and winter sports equipment. It’s very important to check your vehicle’s maximum load capacity to ensure that you are not overloading it, and don’t forget to take into account the weight of the roof equipment itself.
One year ago, I purchased my Thule rack with four H2GO saddles to support my two sit-on-top kayaks. So far 3 out of the four rubber saddles have torn where the pin that passes through the rubber and attaches to the plastic. Even though Thule has graciously replaced them, I feel the H2GO saddles are poorly designed. Thule has replaced my saddles with their new SET2GO saddles.
Finally, a price tag of around 150 bucks is the pretty good value given the high-quality materials and design – though you will be able to find cheaper rear-mounted racks elsewhere if your budget is very tight. Also, don’t forget that this model only has the space to load up two bikes – again, there are options out there with a little more space if you need it.

However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the ProRide 598 and find the bags of various components. Once you’ve installed the ProRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.


No, really, these things are seriously quiet while driving. They aren't inaudible but probably the closest you're gonna get without flat out removing them. I can't imagine any other cross bars being this quiet. And they give you rubber stripping to cover any holes (well, troughs actually) that might otherwise upset the laminar flow and cause unnecessary noise. Very nicely done.

Now, just to complicate matters the Thule Wing bar system is available in two different flavours. You can go for the Thule Rapid system which involves purchasing the bars, a foot pack and clamp system to fit your car. Alternatively the Wing bar can also be purchased in the Wing Bar Edge format which gives an even lower profile and comes complete, but does narrow the amount of carrying space. I therefore went for the Rapid system to maximise the width of the bars.
The WBT31 comes fully built and ready to use. Optional extras include a wall storage hook (£10) if you want to keep it off the floor, a dust/rain cover (£20), good for storing in a hostile environment, and a ramp (£35) for loading heavy bikes or if you aren't happy lifting them vertically onto the rack. The ramp fits all four bike positions on either side and stows securely in a holder on the rack, ready to use at your destination. I always used the ramp for getting our 30kg (plus whatever's in the panniers) Workcycles FR8 Dutch bike on and off the rack – it's fast to use and minimises the risk of slipping and dropping a very heavy bike.
I put these on a 2012 VW Tiguan (using the Thule Rapid Crossroad Foot Pack) and probably should have gone with the 53" version for 2 kayaks. I only anticipated 1 kayak at time of purchase but the collection grew. Ended up getting a Takima J-Low to mount one on its side and one flat on the bars. Very tight squeeze (the J-Lows max weight for 2 kayaks isn't high enough if they are fishing kayaks - 110lbs). The J-Lows are VERY noisy and whistle when empty (gotta break out some duct tape and work on that...) but the bars - you won't notice they are there unless actively listening for them when unloaded.

Now we're going to bring it up to the roof line of our Cherokee. I like to put it across, get that side started over there and do the same thing over here. We want this edge to come below our side rail just like that. That's what's going to give us that good firm hold. Make sure that happens on both sides.Once we've got that position, we need to decide where we want our rail to be.

For sale is a Thule roof rack. It has 4 x 754 rapid system foot for cars with normal roof ( without bars ) and 2 x 120 cm square load bars. It is lockable and comes with 2 keys and original packaging. The bars have scruffs and scratches from use but are in good working order. I hade this on my 2007 Saab 95. Please make sure this model fits you’re vehicle. I can deliver to most U.K mainland post codes for £10. Thanks for viewing.
×