Looking at some recent reviews, you might come to the conclusion that Thule heard all the complaints here about the end caps being shown in the picture, but not actually being in the box and rectified this problem. Some people claim to have gotten end caps. However, like me, you would be wrong in this conclusion. As of June 2015, they still don't include end caps. Maybe these people saying they got end caps got them with a foot purchase? At least in my case when I was just buying the bars to replace the rusty ones on my car, no end caps.
TYRE DEFLATION: This has never happened to me. In theory if this happened during transport then the bike would become considerably more loosely attached. I don’t think it would fall off as the two front arms are locked together in place. If you purposefully deflated the tyres before attaching the bike to the UpRide then I would guess that vibration during transport WOULD damage your wheel rims to a small degree. Thieves MAY deflate your tyres to make the bike OR WHEEL more easy to remove – remember they can easily take out your wheel skewers.
Bought these for use on my Kia Ceed. Very easy to fit following the instructions on youtube. I wanted my roof bars to be as silent as possible and these definitely fit the bill. The only time I actually heard them above normal road noise was when they were covered in dirt and frost which caused them to whistle (which is understandable as theyre not as aerodynamic). Personally I think the thule bars are worth the additional cost.
These are working great so far for a Cargo Box and Canoe mounts on top of our 2017 Subaru Forester. I was leery about these as they sit up a bit higher than the factory crossbars, but the AeroBlades live up to their namesake. Without a load on top, I don't hear any extra noise with them installed and our mileage appears to be spot on with what it was without any cross bars installed. The vehicle's computer calculated ~35.2 MPG doing 70 on the interstate with some front and tail end driving on the streets with a local commute. That's is right around what the vehicle gets without cross bars. If there is a difference, we're talking a difference of decimal points. I had thought for sure that the MPGs would take a beating at highway speeds in particular with cross bars. The only con that comes to mind is that with the Cargo Box (Thule Atlantis 1600) on top, we can't pull into our garage door as it's just a bit too tall. The factory bars, which would sit lower by about an inch or two would likely allow for it, but then we would lose the ability to mount the canoe as the width of the mounting space on the aluminum is significantly reduced with those. With these, you can use the full top of the bar for mounting with the T bolts as well as wraparound accessories. The factory Subaru cross bars only accommodate wraparound accessories as there is no slot/channel for T bolts. For our vehicle, at the foremost mounting point on the roof rails, the spacing between them is 39". The foot packs underneath the bars do come inward a bit, but the usable space between the foot packs for wraparound accessories on the front bar is right around 36" (less on the rear bar), which is more spacious than what the Subaru cross bars would allow for. So far, we are very pleased with this setup!
Well I dont even trust factory racks because of the loads I often carry and for this reason I bought a Mit. Montero with gutters-could have had a newer Monte but the gutters are gone as with most newer SUV's, the gutters allowed the use of Thule bars attached to gutters and not factory racks with stated capacities of around 100 pounds, since I am often carrying two Brittish boats and a fully loaded Thule box in the middle I felt better ultimately attaching to the gutters...using this system I have traveled to Canada and to Key West and to the OBX with the load listed above (with at least 70 pounds of gear in the Thule Box...and have had no problems (yet!)...I do tie down the kayaks from both stern and bow for these trips of 500-1000 miles and also tie down the boats to the bar...I use a combo of Hully Rollers and H20 Saddles...and at every stop check the boat straps.
However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.
Thule makes a beautiful and strong rack system. I was skeptical at first about putting my new bikes on my roof, but after buying and installing my Thule system, I easily carry 4 bikes with no worry. I did buy mine from different people on craigslist, but the build quality Thule puts in these rack gave me the confidence to buy someone's used equipment.
Aluminium bars include T-track slots which allow you to use the full length of the bars for load carrying. The WingBar not only looks good but more importantly includes a device which reduces wind noise to the minimum, as well as reducing drag. Many customers leave their Thule WingBars in place from week to week, especially if they are taller vehicles and fitting is awkward.