Web Analytics

The Outbound ties to your vehicle with heavy-duty, double-stitched webbing straps, while twin compression straps help secure the load to cause minimal friction and noise while driving. Made of double-coated IP-X2, phthalate-free TPE laminate material that’s been certified to be weather resistant, it’ll provide amply protection from all the elements. A three-sided zipper makes it easy to access, and a storm flap that covers the zipper seams reinforce weather protection.
After reading the reviews here by some users who had issues with the older clamps, I contacted Thule support and they offered to send me a set of new metal hardware at no charge. The support rep. said that most of the problems with older design were probably caused by non-use of bow and stern tie downs, and strongly recommended doing this, even with the updated mounting plates. A few weeks later I received the plates, installed them, and everything seems to be solid but I think I'll still be using tie downs just to be on the safe side. Just noticed Yakima is now making racks similar to the Hull A Ports and also recommend securing the bow and stern. Guess they're playing "C-Y-A", too.

The sleek, aerodynamic design cuts down on drag and wind noise, and the quick-release hardware makes it easy to mount; it works with most round, square, and aerodynamic bars, with a minimum/maximum cross bar spread between 24 to 42 inches. As with most Yakima boxes, it’s made in the United States with up to 80 percent recycled material, and you can add a cargo net (separate purchase) that attaches to built-in tie-down points and divides the storage space into four-foot squares. The Skybox comes in five sizes, from 12 cubic feet up to a cavernous 21 cubic feet.
The roof rack instructions are difficult to interpret. Here are tips from a sales person: The picture with the hand sqeezing does not mean completely secure, just means somewhat set in place. You completely secure,and hear the click, when on the car and screwing with the bolt/handle. Also, get the bolt/handle threaded properly into the foot before you shimmy it into the final position on your car, then tighten down. Also, Thule said that front and rear tie downs must be used on a verticle system because the wind force on long boats will tear almost anything off. Still, that piece of plastic is a crummy and dangerous attachment and needs replacing with something far more secure. Fyi Walden also makes a similar J system for kayaks but I haven't seen one up close.
However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.
The data shown here, particularly the database as a whole, shall not be copied. The Data User shall refrain from copying and disseminating the data or the database as a whole and / or from causing such acts to be carried out by third parties, without TecDoc's prior consent. Any violation shall constitute a copyright infringement and shall be subject to prosecution.

1o - Breakage ! The head unit in secured in the bars with a single bolt and it just cant take the continuous side to side loading when driving in unpaved roads (this unit is designed for disk brakes, used in MOUNTAIN BIKES, which trails sometimes required driving in unpaved roads to get to, no surprise here Thule !).Even driving carefuly, my head unit has cracked TWICE and the third time it was the bolt itself that snapped. Almost had the bike flying on the highway...


I contacted Thule's tech services and was told that the aluminum mounting clamps would not hit the field until March 2003 and that it might be late March at that. They will still have the capability to clamp to bars up to 2.5" wide. They will still ship with 50mm and 60mm screws. They also stated that some (maybe all?) of the saddle type carriers would get a four position locking set-up that would allow them to lock nearly vertical for a shell on down to flat for a windsurfer.

The most likely causes of excessive wobble at speed on a motorway are either that you have not placed the arm clamp sufficiently close to the chainring OR you have not tightened the clamp sufficiently. Having said that, there is a further cause where the clamp can slip UP the frame IF your frame gets thinner in that direction (eg My Cervelo S3 does precisely that). In that scenario you will need to put the arm clamp slightly further away from the chainrings at a thinner part of the frame.
Kayaks are a little tougher to secure to the roof of a truck than mountain bikes. The Thule Hullavator Pro Kayak Carrier uses cassette-like side loading system to turn what might be a two person job into a quick and easy activity. “Our Four Wheel Pop-up Campers customers love the Thule Hullavator Pro Kayak Carrier for mounting kayaks, and they make life so much easier with vehicles with a tall roof. The system allows you to load from the side with less lifting and straining, which is key after a long day on the water.”

Strong Securing Points – The bike has to be attached to the rack somehow, and this can be one of the most important parts of the design. The securing points have to combine the strength to hold your bike whilst also being gentle enough to not damage the frame, wheels or paintwork. Don’t underestimate the holding power required either. As your vehicle barrels down the freeway, there can be quite a bit of wind buffeting the bike. It needs to be held securely so you don’t glance into the mirror to see your beloved two-wheel steed flying off the back of the car!
Thule have done the hard work of figuring out how to best fit it to your car, though. You just dial in the angle between the arms, hang it on your car and tighten the straps. You can lock the ratchets, and there's a cable lock to secure the last bike in place so it's harder to steal rack and bike than is typical of boot racks. It folds tidily, but it's not light.
Wobble – This is probably the most important point. I think I’m reasonably good at looking at things and then extrapolating how I think they will work. To me the UpRide design looked like the bike would wobble like crazy. However IT DOES NOT WOBBLE LIKE CRAZY. I would say that I was surprised to find that there is LESS wobble than with the other, cheaper Thule bike roof racks. It seems that fixing the front wheel absolutely solidly is the thing to do.
Thule roof racks & roof boxes are the leading brand of choice for carrying extra loads safely & securely. Need help deciding which Thule roof bars or roof box is right for your vehicle? Our staff have all the expertise to help you make the right choice. We also stock Thule ski carriers, transport / cargo management products and Thule accessories, giving you extra security and versatility.
×