Web Analytics

One caveat is the measurements in the instructions to install the bars are wrong, not really sure where they came up with those (or maybe there were for a different length bar? I went with 60" which seem perfect for my van) but after a little finagling was able to get them evenly set up on my own. Not even worth taking a star off in my opinion, but I can understand if someone were confused or unhappy. I'm mechanically inclined so it was maybe a 10 minute bump in the road, just had to figure out what measurement would be equal from the end of the bar to the edge of the foot on each side of the car, and beware, the front and rear bar measurements will not be the same. I started by eye and refined it by measurement, and put a sharpie marker on the bottom in case I have to remove them, done and done.
No caps included. Really!?! Is this too much to ask? It is hard to believe that ordering Roof racks has so much deception involved. Yakima won't give parts numbers unless you go to a dealer, Thule leaves out pictured parts. Now I have to chase these caps down before installation. What else don't I know about this deal? Make sure you understand what I am saying: If ordering is not clear, it is NOT A QUALITY item. Go to a product that promotes honesty. I am open to suggestions. Right now I am considering sending the whole deal back.
I already had a fairly sturdy factory rack on the roof of Subaru Outback Sport (the economy Outback) and was looking for cradles I could attach to that. I originally bought the Rollercoaster for the front and hydroglide for the back with the Fat Mouth Factory rack adapters. Regardless of what the salesman said, this didn't work (Fat Mouths only work with ski racks). So, I exchanged these for the Hull-a-ports (for about $120 less).
Thule 4027 Top Rack Mounting Fitting Kit Pack of 4. Audi Q3 2012-2018. Condition is Used. Dispatched with Royal Mail 2nd Class. Rubber mounts all in great condition Will be delivered in a box that says kit 4031, but this is kit 4027 (I purchased roof bars with kit 4027 attached and do not need - hence sale) No instructions, but easy to find on internet Sold as seen, grab a bargain!
I should've read the gd item description and reviews before I purchased this because these don't come with the end caps like its pictured. Had I known that, I would just gone to REI to purchase these. Also, the bars look used. I'm sure it'll do the job and it will get dirty eventually, but still.... I paid for a new product. All these mf snakes on this mf plane...

I bought my hull-a-ports along with the Aero-Bars from the Rack Warehouse in the spring (2002). Five weeks after I put them on my car, I had the lower plastic brackets snap on one of them on the freeway which was very disconcerting at 70 mph. Thule sent me new plastic brackets but after reading postings on this and other sites about kayaks flying off cars all over the country - I decided not to risk it. I commonly have to drive 500 x-way miles to paddle. I sent the hull-a-port back to the Rack Warehouse asking for a refund. They said Thule looked at it and because it was "used" (mangled is a better word after the product failure) they couldn't give me a refund. They admit that the plastic brackets are prone to failure and because of that - they are re-engineering them in steel and will send me my hull-a-port and new brackets when they are available. It is now almost November and I have not had the use of it all summer. Apparently it's sitting in moth balls at the Rack Warehouse until God knows when??? If only I would of bought them at REI or some other retailer that stands behind what they sell and will wrestle with the manufacturer for the consumer. Live and learn...
Now we're going to bring it up to the roof line of our Cherokee. I like to put it across, get that side started over there and do the same thing over here. We want this edge to come below our side rail just like that. That's what's going to give us that good firm hold. Make sure that happens on both sides.Once we've got that position, we need to decide where we want our rail to be.
Just about every roof rack company offers a standard bike mount for their racks, but not many offer a storage combo setup like the folks at Küat. The Skinny is designed to allow for a combination of a single bike mount and space for up to 160 pounds of gear, leaving the second half of the roof open for anything else you might want to pack on your adventure.

There are a number of roof rack manufacturers providing equipment that although suits a purpose, is not suitable for carrying canoes, kayaks or bikes as it cannot handle the weight of these items. We exclusively sell Thule roof racks and cycle carriers which are well designed and can handle the weight and bulk of modern sports equipment. We don't sell anything we wouldn't be happy using ourselves and we're a picky bunch!
The Skybox Carbonite is a long carbo box that can handle camping gear for up to four travelers, as well as skis and snowboards up to 215 centimeters long. Designed with internal lid stiffeners, it’s both durable and easy to open and close from either side, with a tapered design to reduce hinge interface and increase internal space for awkwardly-shaped gear. SKS locks come included, and the Superlatch tech ensures that the lid will lock securely to the base to protect your gear.
The hull a port I like it because it fits almost every rack. And like most of the reviews wonder why it has plastic mountings. Well, figured that out one day when driving under a garage where the door was a little low. The clamps under the hull a port broke. But then don't think they were designed to drive into a roof. Have tightened those hex bolts pretty tight, so the plastic bends but doesn't break under designed usage. But the hullaports do shimmy and shake when there isn't a boat attached. The angle of the j-shape fits one of my boats perfectly (Chilco) but on my Quest it isn't deep enough, I would like a better fit.
These car roof bars come with wordless (diagrams-only) fitting instructions that are difficult to comprehend and, in the case of a Peugeot 306 hatchback, specify the wrong assembly settings. The result is roof bars that cannot be fitted to the car or, at best, can be fitted only with extreme difficulty and at risk of damaging both the racks and the car body.
The covers for the the TK8 fit kit do not sit flush on the car. There is a rather substantial gap on the inside edge of the cover. This allows water to get under the trim. Thule recommended smearing a heavy layer of grease on the metal under the rail twice a year so that the metal does not rust. This is a problem. The gap is obvious and also does not look good. Thule has been aware of this problem for a couple of years and have chosen not to rectify it.
I took my time fitting the parts of the Thule Wing bar system together and making sure that they were positioned and setup on the car correctly. I made sure that when positioned I took a note of what the feet of the bars lined up with. In my case they lined up with a couple bits of trim near the B pillar and rear door. This did take some time to get just so, but was worth it as they can now be fitted to the car in a matter of minutes.
I put these on a 2012 VW Tiguan (using the Thule Rapid Crossroad Foot Pack) and probably should have gone with the 53" version for 2 kayaks. I only anticipated 1 kayak at time of purchase but the collection grew. Ended up getting a Takima J-Low to mount one on its side and one flat on the bars. Very tight squeeze (the J-Lows max weight for 2 kayaks isn't high enough if they are fishing kayaks - 110lbs). The J-Lows are VERY noisy and whistle when empty (gotta break out some duct tape and work on that...) but the bars - you won't notice they are there unless actively listening for them when unloaded.
One year ago, I purchased my Thule rack with four H2GO saddles to support my two sit-on-top kayaks. So far 3 out of the four rubber saddles have torn where the pin that passes through the rubber and attaches to the plastic. Even though Thule has graciously replaced them, I feel the H2GO saddles are poorly designed. Thule has replaced my saddles with their new SET2GO saddles.
No caps included. Really!?! Is this too much to ask? It is hard to believe that ordering Roof racks has so much deception involved. Yakima won't give parts numbers unless you go to a dealer, Thule leaves out pictured parts. Now I have to chase these caps down before installation. What else don't I know about this deal? Make sure you understand what I am saying: If ordering is not clear, it is NOT A QUALITY item. Go to a product that promotes honesty. I am open to suggestions. Right now I am considering sending the whole deal back.
Shortly after we bought the rack, our little mazda 2 was rear ended by a texting idiot. Before the car was repaired, I decided to try and test the rack to see if I could damage the tailgate with the rack. I tightened it up really hard and grabbed the mounting arms and shook the car around on it's suspension and it did not bend or damage the tailgates panel edges at all.
Choose aerodynamic roof bars for superior performance and a sleek, sophisticated look that complements the lines of your car. These roof rack cross bars also have many smart design features. A textured surface disturbs the airflow and greatly reduces wind noise. The aluminium extrusion creates one of the strongest load bars in the market. The design gives you quick, no-hassle installation. While the end cap pivots and T-track make it easy to add further loading options.
×