Web Analytics

The Outbound ties to your vehicle with heavy-duty, double-stitched webbing straps, while twin compression straps help secure the load to cause minimal friction and noise while driving. Made of double-coated IP-X2, phthalate-free TPE laminate material that’s been certified to be weather resistant, it’ll provide amply protection from all the elements. A three-sided zipper makes it easy to access, and a storm flap that covers the zipper seams reinforce weather protection.
Seeing a full-on roof rack bolted to the top of an overlander or SUV shouldn’t be a surprise to anyone. For more modest sedans, however, they look a tad out of place. Which is why the Yakima Round Bars make a great alternative. You won’t be carrying fully stocked coolers, kayaks and mountain bikes all at once with your four-door anyway, so there’s no need to go overboard. “We have been using Yakima Load Bars and Storage Boxes for years, both for ski and bike trips, and now even for rooftop storage on our Four Wheel Campers. The Yakima system is proven, classic and adaptable for smaller cars.”
For us, the roof rack that fits us the best is the Thule Hullavator Pro Kayak Carrier. It is probably the most complete roof rack on the market at the moment. We rate it 5 out of 5 stars as we could not find anything to complain on. It comes from a top rated manufacturer and can be adjustable to pretty much any kayak size. Moreover, it makes loading a matter of seconds and can take heavy boats as well.
I bought my hull-a-ports along with the Aero-Bars from the Rack Warehouse in the spring (2002). Five weeks after I put them on my car, I had the lower plastic brackets snap on one of them on the freeway which was very disconcerting at 70 mph. Thule sent me new plastic brackets but after reading postings on this and other sites about kayaks flying off cars all over the country - I decided not to risk it. I commonly have to drive 500 x-way miles to paddle. I sent the hull-a-port back to the Rack Warehouse asking for a refund. They said Thule looked at it and because it was "used" (mangled is a better word after the product failure) they couldn't give me a refund. They admit that the plastic brackets are prone to failure and because of that - they are re-engineering them in steel and will send me my hull-a-port and new brackets when they are available. It is now almost November and I have not had the use of it all summer. Apparently it's sitting in moth balls at the Rack Warehouse until God knows when??? If only I would of bought them at REI or some other retailer that stands behind what they sell and will wrestle with the manufacturer for the consumer. Live and learn...
Seeing a full-on roof rack bolted to the top of an overlander or SUV shouldn’t be a surprise to anyone. For more modest sedans, however, they look a tad out of place. Which is why the Yakima Round Bars make a great alternative. You won’t be carrying fully stocked coolers, kayaks and mountain bikes all at once with your four-door anyway, so there’s no need to go overboard. “We have been using Yakima Load Bars and Storage Boxes for years, both for ski and bike trips, and now even for rooftop storage on our Four Wheel Campers. The Yakima system is proven, classic and adaptable for smaller cars.”

You see we've already got our front rail installed. Just use a reference mark here to make sure we have that in line. You're going to do the same thing here in the backside.Once we have that position from both sides, we want to check the overhang that we have on our bars. We'll just add as well. The overhang's going to be this portion here. I just want to make sure we have equal overhang on both sides. It doesn't have to be perfect, but it certainly looks better if it is. All right. Once we've got that where we want it, you want to grab the tool that is provided. This is a torque limiting tool, so basically it's going to tell us when we have our bars tightened down all the way. This is a four nanometer tool. Right here it says Ford inaudible 00:02:09 Newton meter, this is a Ford Newton meter clamp. So, we'll just start tightening this up. I like to snug this one down pretty well. Make sure that this portion here comes over and makes contact with my race side rail there. Once I get that pretty snug, I'm going to go over and do that other side.Now, these roof rack systems are going to be an excellent way to free up some space inside your vehicle of course. Bike racks, cargo carriers, rooftop cargo boxes, kayak carriers, just all kinds of different accessories that you can put up here on the roof line. Ski and snowboard carriers or really the enclosed ones, even if you want to transport some luggage and stuff like that, keep them out of the elements. Now I'm gonna go ahead and torque this one down until my tool indicates, you see that's just like a gas cap basically. Once it's tight enough, it's just going to click. Same thing here.Now with the Evo Bar, something I do like, you see this cap is going to come right open. That allows us to get into our T-slot accessory and no longer do we have to remove the long rubber strip and cut it. Our accessory can slide right in that gap and almost self seals right around it. Makes it really easy to use. Just pop that back down like that. To finish up our install though, we do want to cap off our end caps here. Tab here is going to go on the top, push that bottom in and at that point, you'll just rotate this 180 degrees into it's locked position to lock that cap on. These are just plastic cores. You can do these using a screwdriver, so if you wanted additional security, you want it to be able to lock and we do have the Thule locking keys you can put in there and then actually have a key lock to keep that nice and protected.The bars do come in a black or a silver, so if you wanted something to blend in with the Cherokee, I'd go with the silver. You want something to stand out, I'd go with the black and then I'll show you on that front bar here on the bottom side, once we get everything in position, we've got a little tab right here. We pull that tab over to our foot pack. That's going to eliminate any gaps in the bottom of that crossbar. Really going to help to eliminate wind noise. You can see right here, just gonna pull that over. It's going to close up that gap. Same thing on our front bar. Th


I replaced my 89 Plymouth Voyager with a 98 Voyager and the roof rack stinks for my canoe and kayak. I replace it with the Thule rack. This rack is strong and sturdy worth every penny. The factory installed racks could slide back and forth and the Thule can't slide with loosening the bolts. I have no intention of ever moving them so I have no problem with this.
The lid has dual-layer construction, which adds stiffness for durability and ease-of-use while reducing drag for better MPG, as well as to lessen the noise. Spring-loaded hinges make accessing the box from either side of the vehicle a breeze, with lockable Smartlatch handles help make sure everything is shut up tight. Clamp mounts make the box compatible with most roof rack bar systems, though you’ll probably want to upgrade to one of Whispbar’s mounts to complete the look.

Aluminium bars include T-track slots which allow you to use the full length of the bars for load carrying. The WingBar not only looks good but more importantly includes a device which reduces wind noise to the minimum, as well as reducing drag. Many customers leave their Thule WingBars in place from week to week, especially if they are taller vehicles and fitting is awkward.
×