Thule Motion XT is not only designed for space efficiency and ease of use, but also to harmonise with contemporary car design. It has a distinctive shape that has been optimised using advanced computer simulation, reducing the impact on fuel economy and providing a quiet ride. With Thule Motion XT, Thule is setting a new standard for modern roof box design, with a stylish, silent and easy-to-use box that will make your car look even better.
The rear strap design now requires the strap to go at an angle rather than directly over the wheel (as with previous Thule rack models). Make sure that you twist the strap clasp lock as well so it points to about 2 o’clock. I’m not entirely sure why this aspect of the design was changed as the straight-through strap always seemed fine to me and was more easily stowed away.
I am not sure if it would be possible to have 3 or 4 UpRide racks on one car. 2 is certainly possible. 3 probably is possible but I doubt if 4 would fit together as the UpRide is wider than the other Thule bike racks. The following image shows the UpRide as the third from the left – as you can see it takes up quite a bit more space (width) than the others. Then again, maybe your car is wider than my estate.
I managed to install two ProRides, the UpRide and a FreeRide simultaneously on one car (ie 4 bike racks). A total of 3 is relatively easy but adding the fourth bike rack required the pedals to be removed from the bikes and was quite a squeeze. If you are going to install 3 or 4 bike racks then you will need to alternate the direction in which they face (forward-back-forward-back) and you will need to ensure that the various closing mechanisms on each of the bike racks are relatively easily accessible. Good luck 😉 !
4. The product information brags about the Smartslide system but installation instructions tell you nothing on how to use it. You can't even find good information on the Thule website. Just be warned that you have to move each foot independently but keeping the same Smartslide number the same on each side so that feet are evenly spaced from the outside of the bar.
My latest car is an estate/touring with a set of roof rails so requires a roofbar that can clamp directly to the rail. After looking at the OEM version I decided to take a closer look at the Thule Wing bars. Mainly because the OEM version sat quite high off the roof and from BMW would have cost a small ransom. I have had a few different sets of Thule bars in the past and still own/use a set of Thule ProRide 591 bike carriers so it made sense to have a look at the newer offerings. In addition Thule have a pretty good reputation world wide and certainly have great customer service here in the UK.
Now we're going to bring it up to the roof line of our Cherokee. I like to put it across, get that side started over there and do the same thing over here. We want this edge to come below our side rail just like that. That's what's going to give us that good firm hold. Make sure that happens on both sides.Once we've got that position, we need to decide where we want our rail to be.
One caveat is the measurements in the instructions to install the bars are wrong, not really sure where they came up with those (or maybe there were for a different length bar? I went with 60" which seem perfect for my van) but after a little finagling was able to get them evenly set up on my own. Not even worth taking a star off in my opinion, but I can understand if someone were confused or unhappy. I'm mechanically inclined so it was maybe a 10 minute bump in the road, just had to figure out what measurement would be equal from the end of the bar to the edge of the foot on each side of the car, and beware, the front and rear bar measurements will not be the same. I started by eye and refined it by measurement, and put a sharpie marker on the bottom in case I have to remove them, done and done.
I was stubborn about getting to the bottom of the noise and tried moving the bar's locations around - test drive, whistle. Tried only the front bar - test drive, whistle. Only the rear - test drive, whistle. Covered the footings in microfiber cloths - test drive, whistle. Covered the Aerobars in microfiber cloth - the very thing/design that Thule markets as being the answer to quiet cross bars... surely the Aerobars were not the culprit... Test drive, silence.
For those in need of some serious hauling capability, this roof cargo bag from Rightline has an hefty capacity of 18 cubic feet and is rated as being 100 percent waterproof. Beware with any fabric roof cargo bags — if not completely filled, leaving the bag to flap in the wind can definitely lead to premature failure. But if you're looking for an affordable option and don't have crossbars, this will do the trick.
This review is of a Thule roof rack fit to my 2011 Mazda3 Sport. Its a basic rack and if installed with care, stays put. The load limit is 100 lbs, so pack with care if you also use a roof box - I've weighed each piece of my gear to and the box itself to make sure I stay within the limits. The rack itself is cheap and works as its supposed to. The only thing I would like is a torque specification so that I don't over tighten and get the dreaded "oil can" popping sound of my roof being compressed (I heard that happen to someone else once, not pleasant). Oh, and I put some 3M protective film down on a clean roof to prevent any paint damage from the foot pads. It looks crappy if I'm not careful wiping away wax, but will protect the paint.
Bought for use on my van's roof to hold a 9'1 longboard - already had roof bars up there which turned out to be too thick for the supplied fixings but wasn't too difficult to make it work. Really quick and easy to use. Haven't tried it with two boards but, as some of the other reviews say, it could be a bit tight to fit another board in with the size of strap supplied.