I took my time fitting the parts of the Thule Wing bar system together and making sure that they were positioned and setup on the car correctly. I made sure that when positioned I took a note of what the feet of the bars lined up with. In my case they lined up with a couple bits of trim near the B pillar and rear door. This did take some time to get just so, but was worth it as they can now be fitted to the car in a matter of minutes.
However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.
Recommended products: The products available in the list are our recommendations based on the information you supply. Change your preferences to narrow down the list of products to match your needs. A maximum of 3 products are listed as default. Where more products are available and applicable, a View all button is available. Press the View details button for more detailed information on a product.
"I have read reviews online on our product before, and fully understand your concern. For the most part I have interpreted that the people that have had bad experiences were not using the product correctly. Thule recommends using a 4-point tie-down. This is so that you equal out the pressure on the carrier, as well as, on the vehicle. I've seen reviews of people stating that they do not use any bow and stern tie-downs. These are the people that end up having their kayaks fly off. If the product is used correctly, there should be no problems while you are driving. So long as you use the product correctly, Thule will stand behind it. If you have any further questions on the matter, feel free to contact us. Thank you."
I bought my hull-a-ports along with the Aero-Bars from the Rack Warehouse in the spring (2002). Five weeks after I put them on my car, I had the lower plastic brackets snap on one of them on the freeway which was very disconcerting at 70 mph. Thule sent me new plastic brackets but after reading postings on this and other sites about kayaks flying off cars all over the country - I decided not to risk it. I commonly have to drive 500 x-way miles to paddle. I sent the hull-a-port back to the Rack Warehouse asking for a refund. They said Thule looked at it and because it was "used" (mangled is a better word after the product failure) they couldn't give me a refund. They admit that the plastic brackets are prone to failure and because of that - they are re-engineering them in steel and will send me my hull-a-port and new brackets when they are available. It is now almost November and I have not had the use of it all summer. Apparently it's sitting in moth balls at the Rack Warehouse until God knows when??? If only I would of bought them at REI or some other retailer that stands behind what they sell and will wrestle with the manufacturer for the consumer. Live and learn...
Aluminium bars include T-track slots which allow you to use the full length of the bars for load carrying. The WingBar not only looks good but more importantly includes a device which reduces wind noise to the minimum, as well as reducing drag. Many customers leave their Thule WingBars in place from week to week, especially if they are taller vehicles and fitting is awkward.