Web Analytics

This is an excellent value single bike rack. The only issue I had was that it took up more space on the roof bars than anticipated meaning the roof box had to be sacrificed due to it's width, and my "budget" Lidl roof bars have a 13mm channel therefore the T-bar fittings couldn't be used. However, the universal fitting kit is very secure. Once on the vehicle, the rack excels...one quick turn of the knob while supporting the bike with the other hand on top of a 4x4 was simple and every aspect of the design has been thought about.
One caveat is the measurements in the instructions to install the bars are wrong, not really sure where they came up with those (or maybe there were for a different length bar? I went with 60" which seem perfect for my van) but after a little finagling was able to get them evenly set up on my own. Not even worth taking a star off in my opinion, but I can understand if someone were confused or unhappy. I'm mechanically inclined so it was maybe a 10 minute bump in the road, just had to figure out what measurement would be equal from the end of the bar to the edge of the foot on each side of the car, and beware, the front and rear bar measurements will not be the same. I started by eye and refined it by measurement, and put a sharpie marker on the bottom in case I have to remove them, done and done.
Always check the vehicle manufacturer's recommended maximum load rating for roof rails. The maximum load rating below is for the cross bars. The load rating for roof rails can vary depending on the vehicles manufacturer. As with all racks, you're going to need to be very aware of your sunroof. On some vehicles there will not be the clearance needed to open the sunroof ie. when the racks are on the roof stays closed.
However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.
I used the rack with a standard road bike and a mountain bike with a big chunky downtube, both were clamped snuggly in place as the rubber lining of the clamp moulds around the tube whatever its shape. We got the quick release wheel straps over a set of Cannondale Knot 64mm deep section wheels and there was plenty of strap to spare. The design of the mounts also means any width of tyre will fit with the possible exception of fat bikes.

These bars are very aesthetically pleasing, having a lower profile and sleek ends which integrate into your car's design well. You do need to buy a specific fitting kit for your vehicle as can be expected. Installation itself took a matter of minutes, however the pictorial instructions do require a bit of patience and imagination to interpret on occasion. They're easy enough to install as one person, but this may be more difficult if you have a van or 4x4. Don't do what I began to do and assume that the thinner edge of the bar faces forward, it's actually the other way around. These bars are very quiet on their own, understandably louder with accessories/roof boxes etc attached - but then the main benefit is that you don't need to remove the whole system to enjoy a quiet journey. If you don't need the accessory then take it off, the bars can stay on and not irritate you like some of the square bars do.


The Thule VeloCompact 92501 is one of the Swedish company's most affordable towball racks and it's really easy to use. It has a wide range of adjustment to suit different types of bikes, and it's very solid and secure. When it's fitted you can still get into your car boot, and it folds flat for storage. It's a good investment for anyone who regularly transports bicycles on a car.

Thule have done the hard work of figuring out how to best fit it to your car, though. You just dial in the angle between the arms, hang it on your car and tighten the straps. You can lock the ratchets, and there's a cable lock to secure the last bike in place so it's harder to steal rack and bike than is typical of boot racks. It folds tidily, but it's not light.
Upright – As the name suggests, this type of rack will hold the bike upright. This is a very safe and secure method of transporting a bike. On the downside, a roof rack itself can have a negative impact on fuel performance though you can offset that a lot by selecting the best roof rack. It can also be harder to load these types of racks, especially with taller cars or heavier bikes. Speaking of taller cars by the way, if you do have an SUV or Minivan, just bare in mind the extra height you now have when driving!
Choose aerodynamic roof bars for superior performance and a sleek, sophisticated look that complements the lines of your car. These roof rack cross bars also have many smart design features. A textured surface disturbs the airflow and greatly reduces wind noise. The aluminium extrusion creates one of the strongest load bars in the market. The design gives you quick, no-hassle installation. While the end cap pivots and T-track make it easy to add further loading options.
×