Fitting the ProRide was pleasingly simple. I’d prepared myself for a long and frustrating afternoon of shouting at the instructions booklet but instead had it all in place in less than 15 minutes. Once the T-screw is in place (in the roof bars) you simply slide the two base plates in to position, feed the T-screw through the holes in the base plate and clamp them down with the cam levers. One of which is locked in place so the whole system can’t be taken off without the provided key.
Less physically strong riders may find its heft a bit much. There are wheels to roll it on flat surfaces, but you wouldn't want to carry it very far. It locks securely to your tow hitch and carries up to three bikes. The bikes are held in place with ratchet straps round the bottom of the wheels and a clamp for the top tube or, for carbon bikes, one of Thule's 982 frame adapters.
I was stubborn about getting to the bottom of the noise and tried moving the bar's locations around - test drive, whistle. Tried only the front bar - test drive, whistle. Only the rear - test drive, whistle. Covered the footings in microfiber cloths - test drive, whistle. Covered the Aerobars in microfiber cloth - the very thing/design that Thule markets as being the answer to quiet cross bars... surely the Aerobars were not the culprit... Test drive, silence.
One caveat is the measurements in the instructions to install the bars are wrong, not really sure where they came up with those (or maybe there were for a different length bar? I went with 60" which seem perfect for my van) but after a little finagling was able to get them evenly set up on my own. Not even worth taking a star off in my opinion, but I can understand if someone were confused or unhappy. I'm mechanically inclined so it was maybe a 10 minute bump in the road, just had to figure out what measurement would be equal from the end of the bar to the edge of the foot on each side of the car, and beware, the front and rear bar measurements will not be the same. I started by eye and refined it by measurement, and put a sharpie marker on the bottom in case I have to remove them, done and done.
To aid you with your rack selection process, The Rack Warehouse lists the most popular selling Thule 460R Rapid Podium Foot Complete Car Roof Rack fits alphabetically by Auto Manufacturer. You'll find perfect fitting roof racks for most of today's top selling vehicles on this list. Thule 460R Rapid Podium Foot Complete Car Roof Racks are designed for vehicles with factory fixed points, rail tracks and bolt through applications. If you don't see your vehicle on this list, simply click on the Thule Fit Guide at the top of the page, enter your vehicle information and the Thule Fit Guide will do the rest.
Upright – As the name suggests, this type of rack will hold the bike upright. This is a very safe and secure method of transporting a bike. On the downside, a roof rack itself can have a negative impact on fuel performance though you can offset that a lot by selecting the best roof rack. It can also be harder to load these types of racks, especially with taller cars or heavier bikes. Speaking of taller cars by the way, if you do have an SUV or Minivan, just bare in mind the extra height you now have when driving!
What a nightmare...spent 4 hours the first day trying to install load bars on my Audi TT (this rack was "specialy designed" for this car...HA!). Returned to dealer several times and they could not do any better. Thule customer service is a joke. They verified the placement of the load bars and the wind deflector is getting in the way of my wipers, WTF! What really iritates me the most is that Yakima does not make a roof rack for my car and I am stuck with this. Going back to dealer one more time to get proper fit, will return and go with Yakima hitch rack if they cant help.
The one addition I’d like to see made to this is a clip to hold the wheel straps out of the way when putting the bike in place. You can tuck them behind the wheel mount, but I found they would often flip back over and get in between the tyre and the mount meaning you had to put the bike down, tuck the strap out of the way again before picking the bike up to put in place. Not a big deal, just mildly annoying.
Based on its versatility, strength and durability, it’s hard to beat the Pioneer Platform range. “We’re running Pioneer Platforms on our Defender 110 and third-gen Tacoma builds, and we have found their system to be durable, affordable, easy to assemble and highly adaptable to a range of uses,” Henwood tells us. “We’ve loaded them with fat bikes, road bikes, camping cargo and with the Rhino Rack Batwing Awning set-up. They do what we ask of them with minimal added weight.”
Look out for our 'One Key System' lock matching offer. When you put Thule products in the Shopping Basket we automatically calculate how many identical replacement lock barrels you'll need so you can lock all your Thule gear with the same key. We'll charge you a nominal price for each of these replacement lock barrels, refunding you the same price for each lock barrel posted back to us.