Grip-friendly outer handles and supporting lid-lifters make it easy to open from either side of the vehicle even when wearing gloves, with a clever slide-lock system with separate locking and opening functions to let you know when the lid’s in place and closed securely. It marries nicely with most after-market bar kits and comes in black, gray, and white.
Lots of negative reviews here I don't understand. Some folks even saying it took 2 hours to put thier bake rack on thier vehicle. That could be the actual problem. They are all pretty simple in design four towers put them on tighten then put your bike on them. Never seen a bike rack that didn't allow the bike to sway some while driving on rough roads. They do make tie down straps for rugged terrain.
The one addition I’d like to see made to this is a clip to hold the wheel straps out of the way when putting the bike in place. You can tuck them behind the wheel mount, but I found they would often flip back over and get in between the tyre and the mount meaning you had to put the bike down, tuck the strap out of the way again before picking the bike up to put in place. Not a big deal, just mildly annoying.
I managed to install one UpRide and 3 of the older style Thule bike racks simultaneously on one car (ie 4 bike racks). A total of 3 is relatively easy but adding the fourth bike required the pedals to be removed from the bikes and was quite a squeeze. If you are going to install 3 or 4 bike racks then you will need to alternate the direction in which they face (forward-back-forward-back) and you will need to ensure that the various closing mechanisms on each of the bike racks are relatively easily accessible. Good luck 😉 !
No caps included. Really!?! Is this too much to ask? It is hard to believe that ordering Roof racks has so much deception involved. Yakima won't give parts numbers unless you go to a dealer, Thule leaves out pictured parts. Now I have to chase these caps down before installation. What else don't I know about this deal? Make sure you understand what I am saying: If ordering is not clear, it is NOT A QUALITY item. Go to a product that promotes honesty. I am open to suggestions. Right now I am considering sending the whole deal back.
However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.
Locking Cables – These are essentially built-in security devices that wrap a sturdy chain around your bike and lock it into place. This has the obvious advantage of protecting your bike from any opportunistic thieves who could look to steal it straight off the rack. Bear in mind that typically you’re only going to see this feature included as standard on the more premium models. Some of the products we looked at above did have a locking cable as an option to buy separately, so check if the rack comes pre-equipped if you want a cable.
I was stubborn about getting to the bottom of the noise and tried moving the bar's locations around - test drive, whistle. Tried only the front bar - test drive, whistle. Only the rear - test drive, whistle. Covered the footings in microfiber cloths - test drive, whistle. Covered the Aerobars in microfiber cloth - the very thing/design that Thule markets as being the answer to quiet cross bars... surely the Aerobars were not the culprit... Test drive, silence.
A change of car has forced me to seek out a new set of roofbars. I wanted the best set of roof bars for my car without going silly on the cost. This time I have went for the Thule Wing bars. These are known as the Thule Aeroblades in some parts of the word. I love cars that can have a set of roof bars bolted to them, either to fittings hidden within the roof or roof rails. The new Unsponsored HQ paddle wagon/family transporter is a very sensible two litre 184bhp BMW 320d Sport.
The ProRide CAN be modified (without any additional new parts) so that the controls can be used on either the left-side or right-side of your car. It’s explained in the manual and take about 15 minutes to do for the first time. As a flavour of what you need to do here you can see that the end of the ProRide comes off and the mounts can then be slid off and turned around to face the other direction.
I can't comment on J carriers because I don't use them, but perhaps I should. The design weakness with Thule is the square bars, which only becomes a problem on curved roofs, but as the roof curves so must cradles cant away from each other, reducing contact between boat hull and cradle to inside edges. The cradle faces are absurdly small to start with; this rotational deviation from level makes it even smaller. Couple that with Thule's comically inadequate détente angle fixing clamp (for holding the saddle in the shape of your boat hull) and for support you are probably better off using foam blocks. So J carriers may work better on a curved roof, if I can lift that high. I've seen some people use them for composite boats so it might be OK.
Anti-Sway Cages – There are a few different ways that racks can be designed to minimize sway, but an anti-sway cage is the most widely used. In particular, you’ll find these on rack designs that hold the top tube, but rear mounted designs that lock the wheels can also benefit from built-in anti-sway tech. In essence, it’s just going to help to keep the bike stable in the rack as you drive. This has the dual benefit of not allowing the bikes to affect vehicle handling (especially at highway speeds) and also stops the bikes knocking into each other.
Part conservationists, part outdoorsman, part storyteller, Matt has devoted much of his life to environmentalism and that crafty, fleeting mistress known as writing. Having worked with over two-dozen brands and lifestyle publications, he’s carried out his passion for all things flora, fauna, and fiction through a litany of written mediums — one adventure, one sentence at a time.
Caveat: I was thinking of replacing the Js with a rail rider or something that I could put an extended crossbar on in order to lay the boats flat. Figured less wind resistance would equal better gas mileage. I was surprised to find on this trip my mileage was better than expected (19+ with a big hemi V8, not great but hey, it goes!)I attribute this to mainly reduced speeds on many of the non interstate highways where we were running 60-65.
So, minus one star for false advertising about the end caps. And minus one star for claiming they don't rust, when I'm replacing them because the old ones are rusted. Otherwise, these things are super solid. I've had at least 2 stand up paddleboards and 2 surfboards on the car at once and there's no question these bars can withstand the strain from wind. If something were to break or bend in the whole car/rack combination, it's not going to be these bars in my opinion.
For your convenience The Rack Warehouse lists the most popular selling Thule rain gutter mounted roof rack fits alphabetically by Auto Manufacturer. You'll find perfect fitting roof racks for most of today's top selling vehicles on this list. Thule rain gutter mounted roof racks require either rain gutters or artificial rain gutters on the roof of your vehicle in order to attach. If you don't see your vehicle on this list, simply click on the Thule Fit Guide at the top of this page, enter your vehicle information and the Thule Fit Guide will do the rest. Once your Thule order is received, we will double check your selection to be sure you have ordered the right rack for your vehicle.
Wobble – This is probably the most important point. I think I’m reasonably good at looking at things and then extrapolating how I think they will work. To me the UpRide design looked like the bike would wobble like crazy. However IT DOES NOT WOBBLE LIKE CRAZY. I would say that I was surprised to find that there is LESS wobble than with the other, cheaper Thule bike roof racks. It seems that fixing the front wheel absolutely solidly is the thing to do.
Be careful with Wingbar Edge. They are supposed to be quieter than 961 bars + 753 foot pack but they are probably not. I both wingbar edge for BMW 5er Touring, with 4022 kit. Plastic cover, covering foot and kit (and securing the rack with the lock) does not fit tight, there is a 2-3mm slot. I suppose this is a reason of whistling, with high frequencies. With box on roof rack I was not hearing that, there was heavy noise coming from the box. After removing the box whistling was so annoying that I removed front bar from the roof on the gas station – I was not able to drive with it on the roof!
The data shown here, particularly the database as a whole, shall not be copied. The Data User shall refrain from copying and disseminating the data or the database as a whole and / or from causing such acts to be carried out by third parties, without TecDoc's prior consent. Any violation shall constitute a copyright infringement and shall be subject to prosecution.