Web Analytics

One year ago, I purchased my Thule rack with four H2GO saddles to support my two sit-on-top kayaks. So far 3 out of the four rubber saddles have torn where the pin that passes through the rubber and attaches to the plastic. Even though Thule has graciously replaced them, I feel the H2GO saddles are poorly designed. Thule has replaced my saddles with their new SET2GO saddles.
You see we've already got our front rail installed. Just use a reference mark here to make sure we have that in line. You're going to do the same thing here in the backside.Once we have that position from both sides, we want to check the overhang that we have on our bars. We'll just add as well. The overhang's going to be this portion here. I just want to make sure we have equal overhang on both sides. It doesn't have to be perfect, but it certainly looks better if it is. All right. Once we've got that where we want it, you want to grab the tool that is provided. This is a torque limiting tool, so basically it's going to tell us when we have our bars tightened down all the way. This is a four nanometer tool. Right here it says Ford inaudible 00:02:09 Newton meter, this is a Ford Newton meter clamp. So, we'll just start tightening this up. I like to snug this one down pretty well. Make sure that this portion here comes over and makes contact with my race side rail there. Once I get that pretty snug, I'm going to go over and do that other side.Now, these roof rack systems are going to be an excellent way to free up some space inside your vehicle of course. Bike racks, cargo carriers, rooftop cargo boxes, kayak carriers, just all kinds of different accessories that you can put up here on the roof line. Ski and snowboard carriers or really the enclosed ones, even if you want to transport some luggage and stuff like that, keep them out of the elements. Now I'm gonna go ahead and torque this one down until my tool indicates, you see that's just like a gas cap basically. Once it's tight enough, it's just going to click. Same thing here.Now with the Evo Bar, something I do like, you see this cap is going to come right open. That allows us to get into our T-slot accessory and no longer do we have to remove the long rubber strip and cut it. Our accessory can slide right in that gap and almost self seals right around it. Makes it really easy to use. Just pop that back down like that. To finish up our install though, we do want to cap off our end caps here. Tab here is going to go on the top, push that bottom in and at that point, you'll just rotate this 180 degrees into it's locked position to lock that cap on. These are just plastic cores. You can do these using a screwdriver, so if you wanted additional security, you want it to be able to lock and we do have the Thule locking keys you can put in there and then actually have a key lock to keep that nice and protected.The bars do come in a black or a silver, so if you wanted something to blend in with the Cherokee, I'd go with the silver. You want something to stand out, I'd go with the black and then I'll show you on that front bar here on the bottom side, once we get everything in position, we've got a little tab right here. We pull that tab over to our foot pack. That's going to eliminate any gaps in the bottom of that crossbar. Really going to help to eliminate wind noise. You can see right here, just gonna pull that over. It's going to close up that gap. Same thing on our front bar. Th
Roof bars are an essential item if you want to fit a roof mounted cycle rack to your car. Designed to work with a car roof rail system roof bars are the base for attaching a range of car roof storage systems including cycle roof racks. Roof bars like the Thule Gutterless Rapid System are available for cars with normal roofs that don’t feature roof rails.
Always check the vehicle manufacturer's recommended maximum load rating for roof rails. The maximum load rating below is for the cross bars. The load rating for roof rails can vary depending on the vehicles manufacturer. As with all racks, you're going to need to be very aware of your sunroof. On some vehicles there will not be the clearance needed to open the sunroof ie. when the racks are on the roof stays closed.
Dear Phil, I have read over the reviews you sent us regarding the Thule Hull-a-Port. Being the manager in charge of returns, warranties, and exchanges at the Rack Warehouse I have had some experience with the problems noted in the reviews. The problem of the plastic mounting hardware breaking has happened before, but it is not at all common. Since we have sold the Hull-a-Port, we have had two sent back to us for warranty of this problem. Both of these racks came back last year (the first year this product was available), and this year's Hull-a-Ports have not been any problem for us. We have sold hundreds of units this summer, without one call about this problem. Usually people get back to us right away if there are problems with the system we sent them. I suggest the Hull-a-Port as an option for many people because of its ease of use and flexibility. If you are worried about the mounting brackets, I would suggest following one of the reviewer's advice and secure the boat down to the bar as well. I always use the load bar to secure my straps because the bars are always stronger than the accessory on top of them. Also, both the box the rack comes in and the instructions tell you that the bow and stern strap is required. To be on the safe side and ease your mind, use the bow / stern straps. Please call me if you have more questions or concerns. Thank you, Mary S., The Rack Warehouse 800-272-5362

Look out for our 'One Key System' lock matching offer. When you put Thule products in the Shopping Basket we automatically calculate how many identical replacement lock barrels you'll need so you can lock all your Thule gear with the same key. We'll charge you a nominal price for each of these replacement lock barrels, refunding you the same price for each lock barrel posted back to us.
×