Web Analytics

The rear strap design now requires the strap to go at an angle rather than directly over the wheel (as with previous Thule rack models). Make sure that you twist the strap clasp lock as well so it points to about 2 o’clock. I’m not entirely sure why this aspect of the design was changed as the straight-through strap always seemed fine to me and was more easily stowed away.
In addition to looping the synch down straps around the factory rack, I run them through the rigging on my boat deck and through the bottom part of the "J bend/brackett" of the rack to get to the factory roof rack. I figure that this way if the Thule rack does give away at least it and the boat have a better chance staying with the truck longer until I can pull over. I hope this helps, overall I think the rack is really a good affordable option that requires some added attention and caution when using but overall it is well worth the money.
The hull a port system is unpredictable as far as safety goes.the PLASTIC clamp that allen wrenches in underneath your cross bars is not sturdy and should be made of some type of metal to make tis a reliable good system.i was driving 20mphs on a dirt road and i heard a crack and my boat almost completely came loose.can you imagine that situation but on a highway doing 60?tragedy waiting to happen! the closer to you roof you yak is the better.even though i have replacement parts coming and will continue to use the hull a port system.
I own a 1989 Jeep Wrangler with a soft top. Awkward at best to find a roof rack. My wife and I are "Fun Hogs", the Jeep fills the bill but is short on hauling room. Thule to the rescue. The extensive listing of brackets and attachments have allowed us to fit the Thule rack to the roll bar. As we go topless during the spring through fall, we now can carry two kayaks & paddles and two bycicles w/spare wheels. As a testament to the durability, we have done the Rubicon two years running with bikes and our sea kayaks aboard. Routine trips into Baja, no problem. Thule's rectangular cross tubing is far superior to the competitions round tube. Although not recomended, at 220lbs. I've stood on the rack to scout trails and beach areas without fear of falling. One tough rack.
I can't comment on J carriers because I don't use them, but perhaps I should. The design weakness with Thule is the square bars, which only becomes a problem on curved roofs, but as the roof curves so must cradles cant away from each other, reducing contact between boat hull and cradle to inside edges. The cradle faces are absurdly small to start with; this rotational deviation from level makes it even smaller. Couple that with Thule's comically inadequate détente angle fixing clamp (for holding the saddle in the shape of your boat hull) and for support you are probably better off using foam blocks. So J carriers may work better on a curved roof, if I can lift that high. I've seen some people use them for composite boats so it might be OK.

Due to the unique set-up of this bike carrier, it was very hard not to worry about our precious cargo when using the SeaSucker Talon QR-1 roof rack. The extremely effective sucker pads stuck like glue, but trundling down the motorway it was always in the back of my mind that the bikes weren’t being held in place by traditional, sturdy nuts and bolts.

However I am going to comment on some of the installation steps and things to watch out for as it is a little daunting to open the UpRide 599 and find the bags of various components. Once you’ve installed the UpRide all of the steps you took will be ‘obvious…in hindsight‘. In the future, mounting and unmounting the BIKE RACK will then only take about 5 minutes per bike rack.

Preloved and the heart device is a registered trademark of Moo Limited. Preloved, The Joy of Second Hand, Preloved People and The Second Hander are trademarks of Moo Limited. Copyright 1997 – 2018 Moo Limited. All Rights Reserved. Use of this web site constitutes acceptance of the Preloved Terms and Conditions, Privacy Policy and Cookies Policy. You can manage cookies here.


Last year I bought a Suburban (now I have two racked vehicles) and bought a set of Thule #450 Crossroads to mount to the factory rails. I was little concerned about the rack coming loose. Not that the rack would have a problem, but rather the factory rails would rip out of the Suburban’s roof. Happy to say, after several 1500 mile trips to Maine and Hilton Head my concerns have been but aside. This thing is as rock solid as I was used to.
As expected. Installation was a little tricky. First I got the wrong 'foot kit' for my vehicle on accident. Once that was corrected, the measurements in the included instructions were wrong for my vehicle. I looked up my kit online, found that there was a new version of the manual with new measurements for my vehicle. This turned out to be a closer fit but still not quite right. I had to 'widen' the measurements slightly... in order to allow the "doors" on the "feet" to close (these are the doors where you use the tool to crank down the brackets to your vehicle body to ensure a snug fit). Once completed, I'm happy with the product, just wish the installation instructions were a little easier to follow. There is an online video available through the 'thule fit guide' which was helpful but also not entirely accurate. I like this product because it is "modular" in the sense that when ski season is over, I can remove the attached ski racks and replace with bike/kayak racks.
Strap Mounted – Designed primarily for vehicles without a hitch receiver. The plus points for this type is that they are typically easier to mount than the other styles, making them perfect for occasional use as you can get them on and off quickly. They are also typically cheaper than the other styles of the rack. On the negative side, as they lack a truly solid attaching point they are not as secure, and you must ensure that you attach them properly before loading up the bikes.
Choose aerodynamic roof bars for superior performance and a sleek, sophisticated look that complements the lines of your car. These roof rack cross bars also have many smart design features. A textured surface disturbs the airflow and greatly reduces wind noise. The aluminium extrusion creates one of the strongest load bars in the market. The design gives you quick, no-hassle installation. While the end cap pivots and T-track make it easy to add further loading options.
×