I’ve spent years transporting bikes in the back of a car, usually whipping out the front wheel, throwing an old grease stained fleece blanket over it and slamming the boot shut before heading off. Bags would be placed carefully around it of course and it took a little more finessing if I was taking a friend and their bike. But I became fairly adept at balancing bikes on top of each other – separated by blankets – and avoiding any damaging movement.
As a final consideration, even though the UpRide will hold practically any bike you can hoist into its ratcheting hook arm, it really shines when securing bikes with wider tires inflated to lower pressures—i.e. mountain bikes, hybrids, cruisers, and fat bikes. Simply put, the hook can grip the bigger, softer tires easier than with the skinny, high-pressure tires found on road bikes.
I used the rack with a standard road bike and a mountain bike with a big chunky downtube, both were clamped snuggly in place as the rubber lining of the clamp moulds around the tube whatever its shape. We got the quick release wheel straps over a set of Cannondale Knot 64mm deep section wheels and there was plenty of strap to spare. The design of the mounts also means any width of tyre will fit with the possible exception of fat bikes.
The sleek, aerodynamic design cuts down on drag and wind noise, and the quick-release hardware makes it easy to mount; it works with most round, square, and aerodynamic bars, with a minimum/maximum cross bar spread between 24 to 42 inches. As with most Yakima boxes, it’s made in the United States with up to 80 percent recycled material, and you can add a cargo net (separate purchase) that attaches to built-in tie-down points and divides the storage space into four-foot squares. The Skybox comes in five sizes, from 12 cubic feet up to a cavernous 21 cubic feet.
The WBT31 comes fully built and ready to use. Optional extras include a wall storage hook (£10) if you want to keep it off the floor, a dust/rain cover (£20), good for storing in a hostile environment, and a ramp (£35) for loading heavy bikes or if you aren't happy lifting them vertically onto the rack. The ramp fits all four bike positions on either side and stows securely in a holder on the rack, ready to use at your destination. I always used the ramp for getting our 30kg (plus whatever's in the panniers) Workcycles FR8 Dutch bike on and off the rack – it's fast to use and minimises the risk of slipping and dropping a very heavy bike.
There are a number of roof rack manufacturers providing equipment that although suits a purpose, is not suitable for carrying canoes, kayaks or bikes as it cannot handle the weight of these items. We exclusively sell Thule roof racks and cycle carriers which are well designed and can handle the weight and bulk of modern sports equipment. We don't sell anything we wouldn't be happy using ourselves and we're a picky bunch!
Two areas of caution: These boats on their sides create a high profile and resistance. If your speed is 70 and you have a head wind of 20-30 (as we did) that's the same as 90-100...a bit much; I'd keep air resistance to 75 or so combined maximum. If the wind is to the side you'll feel strong buffeting at times, slow it down. Without wind we felt comfortable at 70. Kayaks were strapped according to instructions around J and under factory cross bars. Also had bow and stern tie downs to prevent sliding forward or aft.
However - there's no need to fret, at Halfords we offer a market-leading range of roof top bars, roof racks and fittings, from brands such as Thule, Exodus and Cruz as well as our own brand alternatives. Our roof bars will suit all leading vehicle manufacturers, including Ford, Volvo, BMW and Vauxhall and we also offer universal models that will suit many vehicles.
Thule Stacker Kayak Carrier Reviewed by Lisa J (Osceola, WI) — 2011-08-24 13:05:08 We were able to easily mount two sets of the Thule Stacker on the factory roof racks on our mini van, and easily carried our three kayaks that way. The tie down straps worked very well, and getting the kayaks on and off was easy. VIEW MORE REVIEWSShop Thule Stacker Kayak Carrier | Shop Thule
I must confess that I've used the 815s without bow or stern tie-downs, but my two kayaks have not budged at all. I peek at them through the moonroof on my car from time to time, and they've never shifted. It's important that you read the directions on how to secure the two strap assemblies. If you do it correctly, they will not loosen. Thule's buckle bumpers are pure genius for protecting your car and your boat. When I get home one night with only one kayak on the roof, I entered my garage before the door had fully opened. The bow of the kayak hit the bottom lightweight insulated aluminum panel of my garage door and crumpled it, but the kayak didn't budge (nor did it get damaged, phew!). However, in the interest of safety, I have resolved to use bow and stern tie-downs in the future. To this end, I have purchased and installed bow hood loops from Riverside Cartop Carriers on my car.
Anti-Sway Cages – There are a few different ways that racks can be designed to minimize sway, but an anti-sway cage is the most widely used. In particular, you’ll find these on rack designs that hold the top tube, but rear mounted designs that lock the wheels can also benefit from built-in anti-sway tech. In essence, it’s just going to help to keep the bike stable in the rack as you drive. This has the dual benefit of not allowing the bikes to affect vehicle handling (especially at highway speeds) and also stops the bikes knocking into each other.
Finding the perfect Thule roof rack couldn’t be simpler. Choose exactly what you need for your vehicle’s make, model and year. We’ll show you the perfect solution of strong, durable feet and roof bars plus fit kit. Or choose an all-in-one, pre-assembled roof rack that already matches your needs. Finally you can add options such as locks and locking straps so all your bases are covered. With a Thule roof rack, you’re all set to head off on your adventures and make sure you have everything you want with you. When combined with other Thule products, our roof racks are also a starting point for carrying the extra special gear that lets you live your passions – with holders for your bikes, your skis, your canoes or kayaks, and your surfboards. Not to mention extra-secure roof boxes and spacious carrier baskets for special cargos
Once it’s in place you can lock the clamp to secure the bike. You don’t have to lock it to keep it closed, just to prevent anyone else from opening it. For anyone to steal it once this is locked they would need some serious equipment to break the clamp arm or the clamp itself. The times I did leave it unattended I ran a lock through the system just in case.
As expected. Installation was a little tricky. First I got the wrong 'foot kit' for my vehicle on accident. Once that was corrected, the measurements in the included instructions were wrong for my vehicle. I looked up my kit online, found that there was a new version of the manual with new measurements for my vehicle. This turned out to be a closer fit but still not quite right. I had to 'widen' the measurements slightly... in order to allow the "doors" on the "feet" to close (these are the doors where you use the tool to crank down the brackets to your vehicle body to ensure a snug fit). Once completed, I'm happy with the product, just wish the installation instructions were a little easier to follow. There is an online video available through the 'thule fit guide' which was helpful but also not entirely accurate. I like this product because it is "modular" in the sense that when ski season is over, I can remove the attached ski racks and replace with bike/kayak racks.
Choose aerodynamic roof bars for superior performance and a sleek, sophisticated look that complements the lines of your car. These roof rack cross bars also have many smart design features. A textured surface disturbs the airflow and greatly reduces wind noise. The aluminium extrusion creates one of the strongest load bars in the market. The design gives you quick, no-hassle installation. While the end cap pivots and T-track make it easy to add further loading options.