For your convenience, The Rack Warehouse lists the most popular selling Thule 460 Podium Foot Complete Car Roof Rack fits alphabetically by Auto Manufacturer. You'll find perfect fitting roof racks for most of today's top selling vehicles on this list. Thule 460 Podium Foot Complete Car Roof Racks are designed for vehicles with factory fixed points, rail tracks and bolt through applications. If you don't see your vehicle on this list, simply click on the Thule Fit Guide at the top of the page, enter your vehicle information and the Thule Fit Guide will do the rest.
Thule does classify the ProRide as “carbon frame friendly” but only by using the included frame protector. But let’s be honest: this little protective piece of rubber and plastic that secures to the frame is a good idea to use even if you have a steel or aluminum frame for maximum protection of your bike’s paint job. It’s included so why not use it?
We spoke to Tom Henwood of Main Line Overland to see what the pros are using and what’s popular on today’s market. “The best roof rack is the best design for a given application, rather than a particular brand. We help customers select racks and storage systems based on what they intend to carry on their travels, where they intend to go, etc. We look for componentry that maintains a low profile and low center of gravity for off-road driving, so we often choose aluminum roof racks to keep weight down up top.”
You really don't want these on your car at eye/head level without end caps. First, I suspect they'll rust quickly (my old ones rusted even with end caps). Secondly, it's steel that's been cut with a saw- the ends are not jagged but neither are they gently rounded and the covering is shy of the ends by 1/8 inch or so. You hit your head/face on these things and there's a good chance you're coming away bleeding. Third, the ends are ugly without end caps.
I can't comment on J carriers because I don't use them, but perhaps I should. The design weakness with Thule is the square bars, which only becomes a problem on curved roofs, but as the roof curves so must cradles cant away from each other, reducing contact between boat hull and cradle to inside edges. The cradle faces are absurdly small to start with; this rotational deviation from level makes it even smaller. Couple that with Thule's comically inadequate détente angle fixing clamp (for holding the saddle in the shape of your boat hull) and for support you are probably better off using foam blocks. So J carriers may work better on a curved roof, if I can lift that high. I've seen some people use them for composite boats so it might be OK.
These are working great so far for a Cargo Box and Canoe mounts on top of our 2017 Subaru Forester. I was leery about these as they sit up a bit higher than the factory crossbars, but the AeroBlades live up to their namesake. Without a load on top, I don't hear any extra noise with them installed and our mileage appears to be spot on with what it was without any cross bars installed. The vehicle's computer calculated ~35.2 MPG doing 70 on the interstate with some front and tail end driving on the streets with a local commute. That's is right around what the vehicle gets without cross bars. If there is a difference, we're talking a difference of decimal points. I had thought for sure that the MPGs would take a beating at highway speeds in particular with cross bars. The only con that comes to mind is that with the Cargo Box (Thule Atlantis 1600) on top, we can't pull into our garage door as it's just a bit too tall. The factory bars, which would sit lower by about an inch or two would likely allow for it, but then we would lose the ability to mount the canoe as the width of the mounting space on the aluminum is significantly reduced with those. With these, you can use the full top of the bar for mounting with the T bolts as well as wraparound accessories. The factory Subaru cross bars only accommodate wraparound accessories as there is no slot/channel for T bolts. For our vehicle, at the foremost mounting point on the roof rails, the spacing between them is 39". The foot packs underneath the bars do come inward a bit, but the usable space between the foot packs for wraparound accessories on the front bar is right around 36" (less on the rear bar), which is more spacious than what the Subaru cross bars would allow for. So far, we are very pleased with this setup!
These car roof bars come with wordless (diagrams-only) fitting instructions that are difficult to comprehend and, in the case of a Peugeot 306 hatchback, specify the wrong assembly settings. The result is roof bars that cannot be fitted to the car or, at best, can be fitted only with extreme difficulty and at risk of damaging both the racks and the car body.
I own a 1989 Jeep Wrangler with a soft top. Awkward at best to find a roof rack. My wife and I are "Fun Hogs", the Jeep fills the bill but is short on hauling room. Thule to the rescue. The extensive listing of brackets and attachments have allowed us to fit the Thule rack to the roll bar. As we go topless during the spring through fall, we now can carry two kayaks & paddles and two bycicles w/spare wheels. As a testament to the durability, we have done the Rubicon two years running with bikes and our sea kayaks aboard. Routine trips into Baja, no problem. Thule's rectangular cross tubing is far superior to the competitions round tube. Although not recomended, at 220lbs. I've stood on the rack to scout trails and beach areas without fear of falling. One tough rack.
Aluminium bars include T-track slots which allow you to use the full length of the bars for load carrying. The WingBar not only looks good but more importantly includes a device which reduces wind noise to the minimum, as well as reducing drag. Many customers leave their Thule WingBars in place from week to week, especially if they are taller vehicles and fitting is awkward.