Web Analytics

I bought these Aero bars for my 2016 Jeep Wrangler Unlimited. Also purchased the Thule 300R gutter low feet. Make sure you link out to the Thule site to determine the right combinations of feet/bars to fit your vehicle when placing your order. The bars are good quality but installation instructions are a joke. They reference the foot pack for installation instructions. The foot pack tells you nothing beyond a vague illustration on how to install. Here is what I found out after several attempts and gouging out flesh on my left thumb:

After reading the reviews here by some users who had issues with the older clamps, I contacted Thule support and they offered to send me a set of new metal hardware at no charge. The support rep. said that most of the problems with older design were probably caused by non-use of bow and stern tie downs, and strongly recommended doing this, even with the updated mounting plates. A few weeks later I received the plates, installed them, and everything seems to be solid but I think I'll still be using tie downs just to be on the safe side. Just noticed Yakima is now making racks similar to the Hull A Ports and also recommend securing the bow and stern. Guess they're playing "C-Y-A", too.
Thule makes a beautiful and strong rack system. I was skeptical at first about putting my new bikes on my roof, but after buying and installing my Thule system, I easily carry 4 bikes with no worry. I did buy mine from different people on craigslist, but the build quality Thule puts in these rack gave me the confidence to buy someone's used equipment.
They seem solid and well made. I'm just surprised at the way that the coating ends on the bars and the bare steel is open to the elements. I guess I assumed these would come with the end caps, as it doesn't specify that they don't and the photo includes the end caps, while graying out the feet - which I knew weren't included. Seems kinda skimpy to leave that little piece out.
Thule 4027 Top Rack Mounting Fitting Kit Pack of 4. Audi Q3 2012-2018. Condition is Used. Dispatched with Royal Mail 2nd Class. Rubber mounts all in great condition Will be delivered in a box that says kit 4031, but this is kit 4027 (I purchased roof bars with kit 4027 attached and do not need - hence sale) No instructions, but easy to find on internet Sold as seen, grab a bargain!
Thule does classify the ProRide as “carbon frame friendly” but only by using the included frame protector. But let’s be honest: this little protective piece of rubber and plastic that secures to the frame is a good idea to use even if you have a steel or aluminum frame for maximum protection of your bike’s paint job. It’s included so why not use it?
Two areas of caution: These boats on their sides create a high profile and resistance. If your speed is 70 and you have a head wind of 20-30 (as we did) that's the same as 90-100...a bit much; I'd keep air resistance to 75 or so combined maximum. If the wind is to the side you'll feel strong buffeting at times, slow it down. Without wind we felt comfortable at 70. Kayaks were strapped according to instructions around J and under factory cross bars. Also had bow and stern tie downs to prevent sliding forward or aft.
I recently put my Thule J-racks on for their second season of use, only to fine that the mounting hardware is not for its second summer of use. The mounting bars (plastic) are cheap and split easily. There is a bolt inside the mounting bar that is supposed to stay stationary so that the bolt may tighten the rack to the rack. When plastic mounting bar splits, which doesn't take much, the bolt moves around making the hardware useless. Also, the bolts included with the racks rust at the mere mention of water. (Probably not the best thing for a kayak rack). The upside is that the J-rack itself is great, its just the mounting hardware that stinks- which can be replaced. I've yet to do it so I can't speak to how easy that is. Its not a bad rack for $85, just be prepared to replace and be careful witht the mounting hardware aspect of it.
I have been a long time fan of Thule racks and accessories. Then at sixty Mph my two week old Kayak departed the rack still attached to a new pair of Thule Hull-a-ports. Thule make a bomber rack system and the Hull-a-port is a great concept but why the plastic clamps?. The kayak landed safely in a snowbank but I worry about what might have happened.
I bought my hull-a-ports along with the Aero-Bars from the Rack Warehouse in the spring (2002). Five weeks after I put them on my car, I had the lower plastic brackets snap on one of them on the freeway which was very disconcerting at 70 mph. Thule sent me new plastic brackets but after reading postings on this and other sites about kayaks flying off cars all over the country - I decided not to risk it. I commonly have to drive 500 x-way miles to paddle. I sent the hull-a-port back to the Rack Warehouse asking for a refund. They said Thule looked at it and because it was "used" (mangled is a better word after the product failure) they couldn't give me a refund. They admit that the plastic brackets are prone to failure and because of that - they are re-engineering them in steel and will send me my hull-a-port and new brackets when they are available. It is now almost November and I have not had the use of it all summer. Apparently it's sitting in moth balls at the Rack Warehouse until God knows when??? If only I would of bought them at REI or some other retailer that stands behind what they sell and will wrestle with the manufacturer for the consumer. Live and learn...
Due to the unique set-up of this bike carrier, it was very hard not to worry about our precious cargo when using the SeaSucker Talon QR-1 roof rack. The extremely effective sucker pads stuck like glue, but trundling down the motorway it was always in the back of my mind that the bikes weren’t being held in place by traditional, sturdy nuts and bolts.
But before you get a cargo box In almost all instances you’re going to need a roof rack system. These systems typically consist of two cross bars that bridge the width of your roof and can hold your box as well as other sport-specific carriers for bikes, skis, stand-up paddle boards, kayaks, and canoes — even a luxe rooftop camping tent. Depending on your vehicle, you may also need towers to attach the bars to your car and elevate them off your roof; get the same brand for both the cross bars and towers to assure compatibility. The variations on bar kits are staggering, but most major manufacturers have tools that help you narrow your options based on your car’s make, model, and year. The only time you don’t need bars? When you opt for a less-expensive cargo bag, which can sometimes be secured to factory mounts or rails found on some SUVs, trucks, and sedans.

"Was skeptical at first to see how good their prices were until I saw their Yelp reviews. Best prices out there for crossbars and racks hands down. Shipping was quick despite the fact that Rack Warehouse is located in the East coast (I'm from CA). The same positive feedback can be said on the care the items were packaged. For those unsure if this business legit, not only can I attest to the authenticity of this business but Google has their back too. BTW, Google provides complimentary insurance. Thanks Rack Warehouse I wish I knew about you sooner.
Thule’s number one priority is safety – for you and the people around you. Our fit kits ensure your roof rack fits your car as safely and securely as possible. Also, at the Thule Test Center™, our products are only given the official seal of approval once they’ve survived numerous crash tests, wear and tear simulations, as well as extreme heat, cold, damp, sunlight and even harsh chemicals. All so you’re free to concentrate on the adventures ahead.
×